Check the soldering status of the inverter PCB. To begin with, take all the things out of the freezer and remove the back wall inside. This is a defrost error.

After separating MAIN PCB CN51 wire from PCB, resistance value between CN51 1↔2 wire shall be 135 ohm± 7%. Unplug the refrigerator and check the ice maker wire harness connection. Below, you can see Samsung refrigerator display codes for different common Samsung refrigerator models. Only a licensed person can recover the refrigerant (Freon). This will result in the foam insulation melting, which can constitute irreparable damage for a freezer, to say nothing of the ruined appearance. Any cookies that may not be particularly necessary for the website to function and is used specifically to collect user personal data via analytics, ads, other embedded contents are termed as non-necessary cookies. 3-Restore power to the fridge. [])), +((!+[]+(!![])+!![]+!![]+!![]+!![]+!![]+!![]+[])+(+!![])+(!+[]+(!![])+!![]+!![]+!![]+!![]+!![])+(!+[]+(!![])+!![]+!![]+!![])+(!+[]-(!![]))+(!+[]+(!![])+!![]+!![])+(!+[]+(!![])-[])+(!+[]+(!![])+!![]+!![]+!![])+(!+[]+(!![])+!![]))/+((!+[]+(!![])+!![]+!![]+!![]+!![]+!![]+!![]+!![]+[])+(+!![])+(+!![])+(!+[]+(!![])+!![]+!![])+(!+[]+(!![])+!![]+!![]+!![]+!![])+(!+[]+(!![])+!![])+(!+[]+(!![])+!![]+!![]+!![]+!![]+!![]+!![]+!![])+(!+[]+(!![])-[])+(+!! Thus you will reset your display. 0 ohm : heater short, ∞ Ohm : wire.

The voltage of the MAIN PCB CN74 1↔3: should be between 7V~12V. Professional solution to the problem Check if the DC 15V output is less than 13.5V. Part DISPLAY LED Description; R-FAN HIGHEST "a" and "b" at the lowest order digit of the R compartment: In the case of the R-FAN HIGHEST operation, the corresponding LED is turned on. If you have dented your fridge, please, do not use the heat-and-freeze way of fixing it! Call a service technician to diagnose and repair this failure. In this mode, the display stops working, and the unit will stop dispensing ice and water. "d" at the lowest order digit of the F compartment. In the case of the C-FAN LOW operation, the corresponding LED is turned on. This process is automatic. Check it and fix it, if necessary.

In case the fault codes do not reset, you will have to install a new defrost temperature sensor and ice fan motor. Display error: ice making kit is harvested more than 3 times and level error ** Apply to the applicable Ice Maker model. It could be seriously damaged by an unexpected power outage, excessive peak currents, or burned out due to a short circuit in the network. If the reason for the error is removed, the error code disappears after a pre-determined period of time. (Check if any parts have shortcircuited. Samsung refrigerator code 88 88 Originally Posted by Doc Ryan Try resetting it by pressing the top left and right buttons on the display and holding them for 10+ seconds. [])), +((!+[]+(!![])+!![]+!![]+!![]+!![]+!![]+!![]+!![]+[])+(!+[]+(!![])+!![]+!![])+(+!![])+(!+[]-(!![]))+(!+[]+(!![])+!![]+!![]+!![]+!![]+!![]+!![])+(!+[]+(!![])+!![])+(!+[]+(!![])+!![]+!![]+!![]+!![]+!![]+!![]+!![])+(!+[]+(!![])+!![]+!![]+!![]+!![]+!![]+!![])+(+!![]))/+((!+[]+(!![])-[]+[])+(!+[]+(!![])+!![]+!![]+!![]+!![]+!![]+!![])+(!+[]+(!![])+!![]+!![]+!![]+!![]+!![]+!![])+(!+[]+(!![])-[])+(!+[]-(!![]))+(!+[]+(!![])+!![]+!![]+!![]+!![]+!![]+!![])+(+!![])+(!+[]+(!![])-[])+(+!! The device ceases to maintain temperature and works inconsistently, although a check shows that all the components and sensors are normal.

In the case of the R-FAN LOW operation, the corresponding LED is turned on. Only in this case, error 88 will stop to appear on the screen. In the case of the R-FAN HIGH operation, the corresponding LED is turned on. It will not tell you what exactly has failed in it, and you may need to take it apart and check every little part of it. "e" and "f" in the lowest order digits of the R compartment, and the LEDs are all turned off. If the wiring connections are okay, replace the refrigerator temperature sensor. These cookies will be stored in your browser only with your consent. Copyright © 2020 Causes, How FIX Problem Contact | Author | Privacy policy | Cookie Notice. The respective LED will start blinking.

This error signals a rotor lock.

The wire wound around the tube is the water fill tube heater. Hi Brian Did you get this resolved mate, I have the same issue? This error occurs due to an ice maker sensor failure. Display error by detecting temperature of sensor: more than 149‘F (+65°C) or less than -58=F(-50°C), Display error when open error is detected by Water Tank Heater: separation of Water Tank Heater housing part,contact error, disconnection, short circuit, Display "oP/LC-Er" in the panel with alarm: MICOM MAIN LOAD communication error MICOM MAIN. You can hear water bubbling in the refrigerator. After separating MAIN PCB CN51 wire from PCB, resistance value between CN51 4↔7 wire shall be 135 ohm±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hether it can be fixed or part of your fridge (or the entire fridge) needs to be replaced depends on the extent of damage. Have not been - Answered by a verified Appliance Technician. Therefore, if your fridge has been through a ride or changed position in your kitchen, check the water fill tube. Check the water line and its elements that are adjacent to the ice maker. Fisher & Paykel refrigerator troubleshooting, Rangemaster Fridge Freezer troubleshooting, Samsung Refrigerator Error Code 5e and 5 ↓, Samsung Refrigerator Error Code 84c (84e) ↓, Samsung Refrigerator Error Code 85e (as well as 83e and 86e) ↓, Ice Maker Sensor Error- open or short-circuit, connector failure. R-FAN HIGH Our easy to use website hosts one of the largest collections of kitchen appliances online with up to 5000 home appliances and household electrical goods from leading appliance brands such as AEG, Miele, Bosch, Siemens, NEFF, Rangemaster, Smeg, Candy, Caple, CDA, De Dietrich, Gorenje, Hoover, Hotpoint, Indesit, Lec, Liebherr, Mercury, New world, Samsung, LG, Stoves, Whirlpool and Zanussi. Cause is also a temperature reading > 122°or < -58 ° F, Freezer Compartment Sensor Error- open or short-circuit, connector failure. This mode should not be used for cooling food. When the CV compartment defrosting heater operates, the LED is turned on.

If the problem persists, replace the electronic control board. (Resistance value is varied by input power) 0 ohm : heater short, ∞ ohm : wire/ bimetal open (Must power off), After separating MAIN PCB CN70 wire from PCB, resistance value between CN70_1-7 ↔ 1 shall be 63(230) ohm ± 7%. Check the board and wire harnesses using a multimeter. Once you detect the problem, contact Samsung and discuss the issue with them. They may provide a new part even if it is not under warranty. • Condensation or water drops may form if the humidity is too high while the. The voltage of the MAIN PCB CN74 1↔4: should be between 7V~12V. Ask Your Own Appliance Question. This will mean that the unit has entered the test mode and started checking, what will take several minutes. Unplug the refrigerator and pull out the pantry drawer. Please enable Cookies and reload the page. Refrigerator evaporator defrost temperature sensor failure. • This is normal. There are three types of solutions to remove error codes 88 in Samsung refrigerator: In the latter case, it is necessary to press the Energy Saver and Alarm keys (in some models – Lighting). Check if the sensor is open or shorted The voltage between the Main PCB CN30 pins 11 and 12 should be within the 4.1V~0.8V range. The auto close system does not work with the freezer door. remove the refrigerator compartment panel. If error codes 88 suddenly appeared both on the right and left screens of Samsung refrigerator, then anything can be expected from it.

Upload files or images for this discussion by clicking on the upload button below. there was a lot of ice build up on the back of the fridge. Usually, this simple resetting brings a fridge back to normal functioning. Voltage supply to the compressor is too low.

Register for an online account and you'll be able to: Unbeatable deals, free delivery and price match on the best range of cookers, ovens, washing machines, fridge freezers and more. We use cookies to give you the best possible experience on our website. Defrost Sensor Error- open or short-circuit, connector failure. This requires a look into the main control board: test voltage between CN40 #8 and CN40 #9 (it should read about 4.5 VDC). Unplug the refrigerator and check the wire harness connection on the pantry drawer temperature sensor in the refrigerator compartment. Cause is also a temperature reading > 122°or < -58 ° F. This error indicates the Refrigerator Evap Fan is not spinning at the correct RPM or the fan feedback line is open. Check the device itself and its wire harnesses. Unplug it, wait for about 1 minute and plug it back in. In this mode, the display will show OF OF, O FF, OFF OFF, or scrolling temperature bars, depending on your model. The “0f” indicates a so called “showroom mode”, which is present in all Samsung refrigerators. Actually, If there is not a problem, it is desirable to replace Main and Inverter PCB With the oscilloscope after a cable problem confirming, After separating MAIN PCB CN51 wire from PCB, resistance value between CN51 4↔6 shall be 135 ohm ± 7%. The error may signify failure of the ice maker itself. In inverter refrigerators of the earlier models, you should press Power Freeze and Power Cool. In most cases, this happens when a refrigerator is moved around. This error does exist, and it arises from improper functioning of the water fill tube heater. It's past support hour. Check if the sensor is open or shorted The voltage between the Main PCB CN30 pins 11 and 13 should be within the 4.1V~0.8V range. Unplug the refrigerator and check the wire harness connection on the ambient temperature sensor, Refrigerator pantry drawer temperature sensor failure. 1-Unplug the refrigerator or turn off power at the circuit breaker.

Then inspect the fan and clean the proximal area with a flow of hot air. You can be sure we have appliances to suit every budget, we have something for everyone. Defrost on over 80 minutes.

Usually, it means that the sensor is disconnected or not functional.

If there is 84E on the display, it is a very bad sign: the entire DC three speed compressor may need to be replaced. Ice Room Sensor Error- open or short-circuit, connector failure. In other words, the refrigerator always returns to the beginning of the test mode because of the inability to complete it. Please, check all connections around the ice maker (wire harnesses, water line, etc.) To do so, press the Lighting and Energy Saver buttons simultaneously and hold them for about 8-10 seconds.

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